Flexi Factory Skeleton Brachiosaurus! with XXL and 3MF Versions!

ALL Flexi Factory designs are protected by Copyright Law. When you purchase, you do NOT have the right to sell any digital file or printed model of my designs without my explicit written consent.

To legally sell PRINTED models, monthly ACTIVE membership is required through one of two available platforms below:

https://linktr.ee/flexifactory

Please help support the creative work of each 3D artist and NEVER share or sell a digital file.

....................................................

What do you do when you can't figure out how to make a Flexi Brachiosaurus neck that's also poseable? Well...you engineer a new mechanic. 🦾

After doing a crazy amount of test prints getting that neck just right, I couldn't be happier with the results. The shorter back legs and more upright head position differentiate the Brachiosaurus from the Brontosaurus, and makes it the largest of the Sauropods! I have to admit I had to research a bit to learn about the differences hahaha.

As usual, I created two head versions (with and without the eye), a stand, and since this Dino is an herbivore, A little branch it pulled from a tree. Keep your eyes open for the XXL post coming Wednesday. 👀

When Putting the neck together, make sure you separate the large and small joints first. Pay attention to the slot orientation, and snap together 4 large on the bottom, and 4 small on the top.

*Caution: Just like building blocks, they can be hard to get apart once you snap them together.

Included in 2 Zipped Files:

Standard Skeleton Brachiosaurus Version:

• 3mf project file
• Small/short stl links for neck (print at least 4)
• Large/longer stl links for neck (print at least 4)
• Body
• Snap on Head with eyes
• Snap on Head without Eyes
• Lower Jaw
• Branch
• Stand
  *infographic for neck instructions

XXL/Cut to Glue together Skeleton Brachiosaurus Version:

• 3mf project file
• Small/short stl links for neck (print at least 4)
• Large/longer stl links for neck (print at least 4)
• Body
• Snap on Head with eyes
• Snap on Head without Eyes
• Lower Jaw
• Left Arm
• Right Arm
• Pelvis
• Left Leg
• Right Leg
• Tail
• Torso
• Branch
• Stand
  *infographic for scaling and gluing instructions
  *XL photo for reference

Like with all my Flexi's, I went through many iterations to make sure it was strong, and easy to print without supports.

Please feel free to share images of your prints on this page, I would love to see 'em.

Thank you.

P.S. If you like this design, Check out my other models.

https://www.cults3d.com/en/users/FlexiFactory/creations

Affiliate link to my supplies used in the photos above can be found here: https://www.amazon.com/shop/flexifactory

*As an Amazon Associate I earn from qualifying purchases.