February 23, 2025
Description
Min. height 71mm
Max height 118 mm
Instructions:
I set print by object method because different layer heights and ironing.
Main item (bulid plate 1)
0,2 mm layer height
Ironing on top surfaces (I set 35mm/s and 30% (I think the correct setting depends on the printer and the type of filament)
Only a minimal support is needed for the bottom.
Inner rod (build plate 2)
0,12 mm layer height
no ironing
Boost Me
An 8x2 mm magnet can be placed in the bottom.
On a flat surface, push the magnet in to make it nice and flat. Minimal superglue can go into the hole.
If you spray a little PTFE or similar lubricant inside the thread, the rod will rotate much better.
High-speed printing is not recommended due to fine details, acceleration speed decelerated.
It probably won't work if resized.
Check out my other uploads and download and print them. RTX, Aorus, AMD, TUF, ROG, BO6, Minecraft, CS GO
!!! Make sure the print speed and temperature and cooling are set correctly for your printer and the filament you are using !!!
License:
Standard Digital File License
CsTibikeee
