Tumbler Lid Organizer for Stanley, Yeti, Kodi Lids

Please note: If you print with the STL and not the print profile, you MUST slow down your print near the top. Otherwise your results will look like below. I highly recommend you use the attached print profile.

This is an updated “version 2” of my Organizer for Tumbler Lids - It will hold Stanley, Yeti, Kodi, and much more! It allows you to easily stack your tumbler lids on top of another vertically. 

The base is 110mm(4.3 inches) wide and the height is 177mm (7 inches)

Personally I staggered my print speed from 30mm/sec to 5mm/sec then 1mm/sec at the very top:

The original version 1 can be found here. There are no problems still printing version 1, this version 2 model is slightly larger and has the honeycomb base.