Laptop/PC stand foldable and adjustable

This is a foldable and adjustable 3D-printed laptop stand designed to let you easily change both the inclination and the height. It is sturdy, portable, and requires only minimal hardware.

The stand works with laptops from 11” to 15.6”, and can also hold tablets or books.
I printed and tested this model using PLA, but you may use other materials if preferred.

The assembly can be tricky, please verify the photos.

You will find a parametric part to print the exact size of the PC anchor.

Required hardware:

• Phillips screwdriver
• 11 × M3.5 × 14 mm or M3 ( you have 2 profiles)

The whole stand folds flat and can be reassembled in just a few seconds.

I also created a version with printed screw which I currently use, you can find it here https://makerworld.com/en/models/2213329-foldable-and-ajustable-laptop-stand#profileId-2406177 take a look. 

✨ Features

• Fully 3D-printed design 
• Foldable and lightweight – great for travel
• Adjustable angles and height to match your ergonomic needs
• Ventilated structure improves laptop cooling
• Works with 11–15.6” laptops, tablets, or books

💡 Additional Benefits

✅ Adjustable & Ergonomic
Elevates your laptop to eye level, helping correct posture and reduce neck fatigue, back pain, and eye strain. Comfortable for home, office, and outdoor use.

✅ Heat Dissipation
The forward-tilt angle and open structure promote airflow, helping cool your laptop more effectively than lying flat on a table.

⚠️ Disclaimer

I am not an engineer, and cannot guarantee the structural strength or suitability of the design for all laptops. My prototype was printed in PLA, which may deform under high temperatures or heavy loads. Please evaluate the model according to your needs and use it responsibly.

I added more strength adding more walls and infill density, but on my test I didn't, up to you to decide.