*** 2024 okt 01. ***
- The "new less support better version magnet option.3mf" is the latest version I recommend printing it.
You don't need to remove the support from the inside because it won't be, just from the bottom which is two moments. Alternatively the middle of the rod is stronger.
Print per object is set. The AMD has a layer height of 0.2 and the inner rod is 0.12 to get the threading right. - New minimum height is 90 mm and new maximum height is 136 mm.
- An 8x2 mm magnet can be placed in the bottom. On a flat surface, push the magnet in to make it nice and flat. Minimal superglue can go into the hole.
Boost Me
- Print per object is set in the profile.
- A support blocker is set on the threaded rod.
- The AMD needs the support, it takes 2 minutes to get the inside out nicely. You will need a large screwdriver, a small screwdriver and a small pair of pliers. Wait until the object cools down and be careful!
- The AMD is rotated 180 degrees on the Y axis, so the bottom becomes the front of the object, and so you don't see the seam in the middle of the rod as it is on the back.
- I have tested it, I have printed several pieces.
- Adjustable between 88 and 134 mm.
- If you like it, please give it a like and a drop a review if you printed it.
- The little "something" on the tray is mostly so that if you need a few millimeters you can increase height by that much.
If you spray a little PTFE or similar lubricant inside the thread, the rod will rotate much better.
Check out my other uploads and download and print them. RTX, Aorus, TUF, ROG, COD, Minecraft
CsTibikeee
