October 7, 2024
Description
Min. height 66 mm
Max height 113 mm
No support need.
Boost Me
Instructions:
The TUF logo should be printed flat with a layer height of 0.2 mm.
Ironing on upmost surface (I set 30mm/s and 30% (I think the correct setting depends on the printer and the type of filament) I used P1P and PETG.
The adjustable inner rod is printed separately with a layer height of 0.12 to make the thread easy to rotate.
An 8x2 mm magnet can be placed in the bottom.
On a flat surface, push the magnet in to make it nice and flat. Minimal superglue can go into the hole.
High-speed printing is not recommended due to fine details, acceleration speed decelerated.
If you spray a little PTFE or similar lubricant inside the thread, the rod will rotate much better.
Check out my other uploads and download and/or print them. RTX, AMD, ROG, Aorus, COD, Minecraft
!!!Make sure the print speed and temperature are set correctly for your printer and the filament you are using!!!
License:
Standard Digital File License
CsTibikeee
