December 4, 2024
Description
A bit holder to collect up to 60(!) 4mm mini bits.
The small size makes it perfect to store your mini bits where you want. The size is only 11 x 3 cm!
IKEA Skadis owner: Take a look at the bit holder with Skadis mounts here → https://www.printables.com/model/1019862-skadis-bit-holder-for-60-14-mini-bits-for-ikea-peg
Printing: PLA without supports is just fine.
One tip in case you have problem to fit the bits into the holes: After printing, use a bit and a pliers to remove any unevenness from the bit holes. This is easily done by inserting and removing a bit a few times. There should then be no more problems with the accuracy.
If you like my model(s) please leave me a like to support my work. Thank you!
License:
Creative Commons — Attribution — Noncommercial — Share Alike
10
3dprints4life
