Center Console Phone Holder/Mount for Hyundai Ioniq 5

Many of the phone holders for the Hyundai Ioniq 5 either block the air vents or the screen.  I designed this phone holder to slot into the unused space between the cup holders in the center console and keeps the phone in easy reach and vision of the driver without blocking anything.

In addition to the three 3d printed parts, you will also need:

• 3 @ M2.5 hexagonal nuts
• 2 @ M2.5x10mm socket head screws
• 1 @ M2.5x25mm socket head screw
• 1 phone mount that connects to a 17mm ball joint.

Printing Instructions

Material

PETG or ABS so that it can withstand hot summer days in a sealed car.  PLA will deform in the summer

Print orientation

The part that goes into the cupholder is designed to be printed with the large flat surface down and will need minimal supports.

The arm is designed to be printed with the long flat side down and will also need supports.

The ball should be printed with the alignment pins facing up and may need supports depending on your printer.

Print Settings

The ball should be printed with a smaller layer height (0.1mm) and with at least 25% infill and 3 walls.  I prefer gyroid for all my prints.

The other two parts can be printed between 0.2-0.3mm layer height.  I recommend ≥15% infill.

You may want to add some sand as ballast if you take corners hard.  Pause the print of the stand at about 70% and pour in some sand or other granular material.  When the print is finished, that will settle to the bottom. 

The center of mass when the phone is attached is higher than ideal.  It is fine with the cup holders full, but if you don't have a bottle there and take a hard corner it can tip over.

Assembly

All of the parts have alignment pins and holes so you can easily put them together.  

1. The 25mm screw goes through the ball and there is a cavity for the nut in the back of the arm.  
2. The arm then goes into the slot in the base and there are two slots in the side for the M2.5 nuts.  
3. Then add the two 10mm screws from the bottom.
4. Attach the phone mount as you would to any ball joint.

See my other models for the Hyundai Ioniq 5