Kadett GSI/Monza GSE odometer gear

After trying out the gear published on thingiverse in the actual odometer, I've discovered that the little indentation that hooks to the number pin was not deep enough. The original has a deeper indentation compared to this model. So I fixed it.

It could be that the Monza GSE gear is a tiny bit different than the Kadett GSI gear, but I doubt it.

I found that printing the part with the gear towards the build plate gives the best finish at the indentation side.

Print Settings

Printer Brand:

Prusa

Printer:

**Rafts:**

Doesn't Matter

Supports:

**Resolution:**

0.1

Infill:

**Filament:** prusament pla

Category: Automotive