Xmas Coaster

On Xmas table you have your nicest table cloth on and your guests handle their wine glasses carelessly, you will end up having stains that will not come off.

This coaster will save you!

Included is STL file with single coaster and BambuStudio 3MF file with 5 coaster. If you have Bambu X1 or P1 printer 5 coasters fit your print bed, with A1 and Mini just remove excessive copies.

You can print this coaster with single extruder, just set filament change to layers listed below. You can change the cup/scarf color to anything you prefer, it will not affect anything else. 3MF already have correct settings and color changes in it. With just one AMS, put 5th color to same slot as 1st filament after it has been printed.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm!

Swap Instructions:
Start with Black
At layer #5 (0.56mm) swap to Red
At layer #10 (0.96mm) swap to skin color
At layer #14 (1.28mm) swap to White
At layer #21 (1.84mm) swap to Light Blue (or your choice).

I used these filaments: PLA Sunlu Meta Black (TD: 0.3) - PLA Sunlu Meta red (TD: 7) - PLA Fillamentum Mukha (TD: 3.5) - PLA Sunlu Meta White (TD: 6) - PLA GST3D Light Blue (TD: ?)
 

Coaster size is 90x90mm and it is 2.1mm thick. Picture was made with Bing image creator and then heavily edited by me. STL was made with HueForge 0.81.