Die wrench

 27mm/1 inch die wrench with and with out handle. 

Requires M4 0.07mm screws or blots (please use at lest 3 to hold the die securely in place). the threads wont print comply but there is enough for the screw to grab on and not move (the screw will cut the thread as you use them after a few times and till be good to go).

Made it slightly larger then 1 inch so its easier to fit dies in. 

The one without a handle is made to fit into a vise as shown in the pictures, while the one with the handle is to be used as a regular wrench. 

Keep in mind that this is not a toy nor isn't a replacement for the real thing. if you are in need of a die wrench get your hands on a quality one. this one will not hold up to the torque required to create threads, it is meant to clean or cut them in soft plastic parts (link 3d printed parts).