HueForge - Fatum Betula Cover Art

My first HueForge project where I was reminded not to trust people-from-the-Internet's data values explicitly; I needed to do two prints to correct terrible coloring from someone else's TD calculations. This print uses 5 unique filaments.

For this project I use a defunct brand of filament, so make sure you use a comparable filament for color and transmission distance to replace 3D Solutech filaments, if you're going off of exactly what filaments I used.

---

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

The Model is 133.33x200mm in size
You may print at higher layer heights below the Min Depth of 0.52mm
The Max Depth is 2.3mm and the Actual Depth is 2.4mm

Filaments Used:
PLA Elegoo Pro Black Transmission Distance: 1.8
PLA 3D Solutech Gray Transmission Distance: 4.6
PLA Hatchbox True Blue Transmission Distance: 6.4
PLA 3D Solutech Mint Transmission Distance: 4.8
PLA Elegoo Pro White Transmission Distance: 3.2

Swap Instructions:
Start with Pro Black
At layer #13 (1.16mm) swap to Gray (If I were to remake this I'd swap at 12, but you do you.)
At layer #15 (1.32mm) swap to True Blue
At layer #16 (1.4mm) swap to Mint
At layer #18 (1.56mm) swap to Pro White for the rest.