February 11, 2022
Description
Do you find that flowers take up too damned much room? This collapsing rose may be just the answer! Prints as a bud and then unfurls to its full glory. Easy to store until the next love of your life comes along.
Printer Brand:
MakerGear
Printer:
M2
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Notes:
Use 0.4mm line width.
UPDATE: I've added a version (flower_tab.stl) with tabs and slots on the petals that makes the alignment easier when gluing, although this version is not quite as attractive.
This does require a drop of super-glue on each petal to hold them in place.
UPDATE: If you are using the version with tabs and slots, you may need to first clean up the slots with an x-acto knife.
Category: ArtLicense:
Creative Commons — Attribution — Share Alike
LoboCNC
