July 4, 2025
Description
This design holds a Stiltz elevator remote using the wire from an original wall mount that comes with the remote. It slips around a floor jack (2.25" diameter top pole, 2.5" diameter bottom pole) without any additional attachments required. It rests on the lower, larger diameter pole and does not pull off. Holes are included in the model if it is desired to permanently secure it to the floor jack with zip ties.
This was printed with PETG and minimal supports were used from the build plate just for the rounded part near the build plate. The FreeCAD 1.1 model is included and is parametric.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Teraflop
