February 20, 2023
Description
Do you find yourself with a problem?
Not a big problem, but quite specific and it's bothering you?
Then you arrived at the right place!
Sometimes when printing a lot with the Prusa MK3/MK3S/MK3S+ and starting new prints without cleaning the nozzle, if some filament is left dangling in the nozzle it ends up on the left side of the printer, creating a mess of filament leftovers.
Can you clean each filament bit by hand as it happens, or even clean the nozzle before every print? Yes! But you might forget, or you require a complex solution, if so, this is it.
I remembered seeing KalleKnall design and since I didn't need any space for tools since I use a Prusa Enclosure with Drawers I remixed the design to be a bit smaller and fit between the frame and motor.
I suggested printing it with supports enabled.
Prusa MK3 / MK3S / MK3S+ - SideBoxes for some Tools by KalleKnall
License:
Creative Commons — Attribution — Share Alike
7
Celta
