2x3 Stud Lumber Foot for Table

Update 01/13/2026: turns out the test foot model was the best option for where I was putting the table. They worked a treat to keep the wood from directly contacting the cement and fit well enough.

This is a 2x3 foot for the bottom of a table I'm working on. The current uploads likely aren't the finished design as I'm probably going to use a very thin bottom in the end to save on solid plastic infill.

But I'm trying a larger gyroid stack first to see how it holds up. And I didn't want to forget to upload it. So here you go!

The smaller test print is for fitment in case the 2x3 in question isn't exactly 1.5x2.5. I would print it first, personally, and check if it fits and then up/down scale the full print for a tighter or looser fitting part.

Also, the test part will make an excellent 1.6mm wall shoe in case that's all you need.

Wall size is 1.6mm all around excepting the bottom which is quite a bit larger.

Please drop me a note if you'd like the dimensions re-spun and I'll see if I can push out a new model.