Quick Reload Holder for Toilet Paper/Paper Towel (Remixed - Screw Attachment)

This is a simple remix of a toilet paper/paper towel holder originally created by “PattysLab” and remixed by PjotrStrog. The only change I made to it was adding screw holes so that I could attach it that way instead of using double sided tape. Double sided tape has come a long way, and some of it is very good, but I still consider it a last resort and would prefer to have it screwed down, especially in a garage where I'm not terribly concerned about putting holes in things.

I printed this from White and Black PLA (EconoFil from filaments.ca) at a 0.3 layer height with 40% gyroid infill. The “peg” piece didn't stay attached very well and I ended up gluing them in place with a gel superglue. Just be sure not to accidently glue the lever to the base.

If this design was useful to you, please post a make!

Many thanks to the original creator, and be sure to check out his updated premium model which you may prefer at:

 https://cults3d.com/en/3d-model/home/quick-change-toiletpaper-holder

It has several nice improvements cosmetically and functionally.