April 9, 2022
Description
This is a remix of "Sleeve Case for Raspberry Pi" I added a 40x40x10mm fan slot to it for cooling
You can feed the fan from raspberry pins
Make the fan push air to out side of the case
I used 12v fan (raspberry pins can only feed 5v) for lover rpm
Attached case to side of my printer to use OctoPrint
I have tested it with Raspberry 3b+ but I m sure it will work with Raspberry 3 either
If you slicing with Cura three support would be useful
You can print case and cap at the same time
Printer:
4GenPro 2R
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
20
Filament:
3D4E STHBlack
Notes:
You can print it with PLA STH ABS it do not matter
License:
Creative Commons — Attribution
9
AfroPsycho
