April 9, 2022
Description
This is a simple 2 piece stand for the A500 Mini.
Print the 2 parts with 100% infill to make sure there's a little bit of weight to them.
0.2mm layer height works well, but pretty much any height should be fine for this.
This was printed in Prusament Vanilla White PLA, but most materials will work well for such a simple print.
Once printed just pop the A500 mini in the 2 stands and slide the stands out so they are touching the inside of the rubber feet(seems to offer the best fit and stability).
.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
RetromanIE
