May 18, 2022
Description
So I got bored while in quarantine, I have been printing Montana Masks for the local hospital and I decided to make an accessory to add just a bit of humor and creep out factor.
This is only the beak, filter and some cheesy goggles.. I am redesigning the beak to make a bigger straighter one.
To make this you will need to print a Montana Mask from https://www.makethemasks.com/
When you print the mask, scale it down to 98% to fit this item (or scale this up to 102%)
the filter piece fits into the beak and the mask together. you will need to provide some sort of filter material (piece of surgical mask or other similar material)
The beak prints with a sacrificial bridge that will need to be cut out.
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
.3 (must be .3 to print properly)
Infill:
10
Filament: cheap PLA black
Notes:
This needs to needs to be printed at .3 layers otherwise the sacrificial bridge will be VERY hard to cut away. as it is now it is 1 layer thick and if you printed with thinner layers it will get harder to remove as layers crosshatch..
License:
Creative Commons — Attribution — Noncommercial — Share Alike
HAL_9000
