[WIP] CR10 standalone case (splitted)

**This remix is currently 'work in progress'

Surely a few things might change in the future ;)**

2022-03-17

LVC_SKR_1.3_1.4_PI4B_V3

• SSR passage position should be corrected, not printed/tested yet
• RaspberryPi standoffs redesigned to avoid the formerly needed support
• removed some holes at the split for an easier printing without support for the SSR hole

Danger letters v1

• Z axis extended to 1.2mm

SolidState_Cap_V2

• Widened the cap +2mm (maybe more is needed, will test later)

2022-03-16

Box_High_VoltageV3-_Meanwell

• reworked the high voltage box to fit a Meanwell SP200-24 power supply
• changed the hole for the SSR to fit better to the alternative power supply
• removed some holes at the split for an easier printing without support for the SSR hole

Cover_high_voltage_V3_1

• deepened the letters to 1mm and widened them 0,1mm at the edge so it's possible to press in the letters (i've expanded them to 1,2mm in z)

Cover_high_voltage_V3_2

• Widened and added additional air vents to make sure the power supply will get enough air

**Attention!

The low voltage box has to be reworked too, because of the changes made to the high voltage box regarding the SSR.**

Category: 3D Printers