Klackers (Print in place)

These are klackers or noisemakers that print in place as one part!

To have a successful print, you must have good adhesion to the bed. If not use helpers or a brim. For the loudest klackers, more walls and infill the better but watch out for curling. If you have issue with curling, enable z-hop, or increase the amount of plastic after the tangency of the balls.

Getting them to Klack, if are having a hard time getting them to klack I found the easiest way to get them started is to set them flat on a table so the klackers are spread out and as you pick them up off the table whip them back down to make them klack. There are two techniques; the single klack and the double klack as demonstrated here.