June 18, 2022
Description
Do you have a FW3A flashlight? Are you not using the clip or lanyard ring? Does it annoy you when you place your light on a table and it starts rolling away?
Stop it, FW3A! Don't roll away! This is a simple ring similar to the lanyard ring, but without a hole. Just remove the tailcap, put it on and screw on the tailcap again. (Depending on your printer accuracy you might have to tune the dimensions slightly. Print in 0.1 mm to get the right thickness.)
Customize it! Use the filament color you like to add some nice highlight to your FW3A.
Category: ToolsLicense:
Creative Commons — Attribution — Noncommercial — Share Alike
10
SammysHP
