Simple Coaster

Simple large round coaster for coaster needs.  Branded with Sleepy Lounge on the top and raised foot for bottom to sit nicely on most surfaces.  I daily use a large mug so the coaster is sized at a 115mm diameter.  

Print the flat top with the lettering face down on the build plate.  Prusament Orange PETG at 0.20mm layer height and 15% gyroid infill.  I Recommend changing overhang/bridge angle to 45 degree or 315 degree, depending on how the lettering is oriented.  This is to make sure the bridge angle has minimal travel for the lettering.  To change bridge angle in Prusaslicer, enable advanced view and go to Print Settings → Infill → Advanced → Bridging angle.  You can set the angle value and see it in the preview slice.