Screw-Top Desiccant Container Funnel

A funnel that screws on top of the container like the lid.

Helps in getting the silica gel in the container, sometimes the silica goes everywhere but the container.

Printing

Like the container, it must be printed in vase mode.

Although it might be obvious, don't forget to print without bottom or top layers 😅 (thanks greenbigfrog)

I've had success with 0.2mm layer height for the body, and 0.15mm for the thread (also to match the container thread layer height).

Tried printing at 0.3mm but it was too much, the layers weren't sticking.