Wemos D1 Mini Temp-01

I'm starting to add some "smart" devices to the families house. This one can house a Wemos D1 mini and a DHT22 sensor. The design is straight forward, no fancy mounts or places for screws, because I'm using parts that I already have. So relays, clamps and converter might change from build to build. Just hot glue in the components and snap the case together.

If you're interested in this one, you might want to check these, too:

https://www.prusaprinters.org/prints/17287-wemos-d1-mini-plug-04
https://www.prusaprinters.org/prints/16723-wemos-d1-mini-plug-03
https://www.prusaprinters.org/prints/16607-wemos-d1-mini-plug-02
https://www.prusaprinters.org/prints/16445-wemos-d1-mini-plug-01

Print instructions

Category: Electronics Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: No

Supports: No

Resolution: 0.25mm

Infill: doesn't matter

Filament: Das Filament PETG Weiß / white Post-Printing

Wire up the components, hot glue the components to the bottom plate (roughly labeled) and click the bottom and the cover together.