August 30, 2023
Description
This model is a remix of Eplolako's model. I printed his and painted it (see photos) but it's printed horizontally on the bed from the middle up since he split the entire model down the middle. This causes a very noticeable loss of details in the parts and requires a LOT of gluing (6 parts with no alignment pins)
When I was gluing it I figured out it could be printed as two parts with much better quality oriented vertically which would make for a much faster, easier print with much less post processing.
My print holds together no problem without any glue since the magazine part is a tight snap fit
I fused together the models for the handle and main body which should be printed upside down with supports (recommend 0.25 mm support Z-distance for PLA printing if you are printing at 0.2mm layer height)
All bodies available in a separate file and in a combined file auto oriented for a Ender 3 sized bed
Printed in Prusament Galaxy Black with these settings
This took about 14 hours to print on my Ender 3v2 running Klipper at 150 mm/s
This design can be improved upon further, feel free to remix!
License:
Creative Commons — Attribution — Noncommercial
Rozzo
