Pikachu Keycap

This is a simple keycap with Pikachu on it.

The original model comes from https://www.thingiverse.com/thing:1200732 but I converted the model to STL and oriented it in the way you should print it.

The model on the pictures was printed on an Anycubic Vyper.

• No supports (make sure to enable bridging in Cura)
• Layer height: 0.16mm (the lower the better, the Pikachu is pretty small)
• Nozzle width: 0.4mm
• Infill: 20% cubic subdivision, but anything will probably work
• Print time: around 35 min