Sim rig triple monitor extrusion brackets

T-slot extrusion brackets for the outer 2 monitors of triple monitor setups for sim racing rigs. They are adjustable from 30-60 degrees.

10 or 25 series brackets works with SAE 10 series (1"x1") and Metric 25 series (25mmx25mm) extrusion and either 1/4" or M6 hardware.

15 series brackets work with SAE 15 series (1.5"x1.5") extrusion, and either 5/16" or M8 hardware.

"Pass thru" versions allow the rear extrusion to pass through the bracket, so that the side monitor can slide along the rear extrusion for more adjustability, but is bulkier and may require you to space you center monitor out a bit. The non pass through versions require the rear extrusion piece to be cut to size to fit your monitors, but may give more clearance behind your monitors and everything will sit tighter to the extrusions.

2 pc designs are easy to print and can be scaled in Z if you want them thicker. 1 pc design may require support, but will be stronger.

Print Settings

Printer:

P902

Rafts: 

Doesn't Matter

Supports:

Doesn't Matter

Resolution: 

0.2mm

Infill:

lots, 35% or more recommended

Filament:

any pla, abs, petg 

any

Notes:

Print lots of perimeters and top and bottom layers, I've found 0.2mm layer height to be strongest.