Guitar Amplifier Organizer (vase mode!)

This is fun little pen holder in the shape of a guitar amp half stack. Pay attention to the settings below, and you should be able to print this very quickly and have a great result. 

I've also included a “blank” bottom template if you want to add your own name.

Print Instructions:

Black-Cabinet__Vase
Use vase mode! yaaay for quick prints. Enable the “fuzzy skin” settings in your slicer to get a pretty authentic looking tolex finish on the amp. Quick tip for Cura 5 users- there's a bug that doesn't allow you to use both fuzzy and vase mode at the same time. Try Cura 4 if you run into that issue.

Gold-Controls
Print normally, with the knobs facing the sky. Use supports

Black-Handle
Print two of these normally, no supports needed.

Multi-Bottom & Multi-Top 
(front meshes & white border on the amp)

• These can be printed together. 
• Disable top & bottom layers. 
• Use a grid infill of 80%
• Wall line Count of 2
• Set your slicer to pause & request a filament change around layer 4 when the borders and logo start to print.
• Load black filament first, and then swap to white when needed.

Aren't equipped to change filament at a specific layer height? I've included a folder where you can print those items on their own, but it will be trickier to assemble. 

Once it's all printed, superglue the bits together and enjoy!

Post a make! I'd love to see them!