Magnetic Nintendo Switch Game Card Travel Case

There are 5 pieces total -

Casing - this is the main white piece in my post, it should be printed standing up with the opening at the top, rather than laying flat on one of the sides. 

Labels - There are 2 labels and they are each unique (don't print 2 of the same) so that the logo looks the same on both sides. I printed them both at the same time with the logo facing up, and I paused the print and swapped white for red when the first layer with the logo started. 

Rack and Cap - The rack itself is what holds the 8 game cards. It should be printed in the orientation as if you would slide the games in from the top. The cap should be printed with the flat side down and then the rack easily super glues into the indentation on the cap. I wanted this to print strongly and with no supports, which is why I split up the two pieces.

----------

There is room inside the case for magnets if you want to superglue a small magnet to the butt end of the rack, and to the back wall inside the casing. This makes it so the rack wont slide out when it's put in a backpack or something. But it's easy enough to still pull the rack out as well. There is about 6mm of space allowed for magnets, I used some small neodymium magnets I found at my local Home Depot.