New Angled Coupler for PTFE Tubing [PC4-M10]

I redesigned my 40° coupler from the ground up! The Fusion360 design is now more parametric, so if you want to mess with the angle, get the source here!
https://a360.co/2BwCLdH
It's also shorter, and has a smaller footprint in general. It uses my new design for PC4-M10 interfaces.

This print works better if your PTFE tubing is chamfered at the end; guiding the filament in. Here is a fantastic tool I use to chamfer the ends of my tubing:
https://www.prusaprinters.org/prints/46984-ptfe-tube-60deg-chamfer-tool-by-printschnitzelat

Here is my original design for this coupler. It may be easier for you to print.
https://www.thingiverse.com/thing:3746615

Here are the PC4-M10 couplers I bought:
https://smile.amazon.com/dp/B078SRBDS7/

Here are the 3M Command Strips I use:
Learn more:
https://smile.amazon.com/dp/B0751RPC6Q/

Print instructions

Print with Supports

You can easily remove the supports at the end by poking them out from the other side with an allen wrench or something.