August 15, 2020
Description
Bought a new power supply for my MPMD and wasn't happy with the exposed mains lines, so I designed this to hold it in place without screws and for a little airflow from bottom to top.
The power supply I made it for is the Mean Well LRS-150F-12 Power Supply and the snap in EIC mains socket, so double check your dimensions before committing!
I mounted it with hot glue and then an edge of silicon. The 4 holes are not to be used with screws, as they will either touch or come incredibly close to the back of the mains. I will not be to blame if you electrocute yourself. The holes are only intended for extra surface area for glue to stick.
Unfortunately cannot be printed on the MPMD it was designed for.
Bought a new power supply for my MPMD and wasn't happy with the exposed mains lines, so I designed this to hold it in place without screws and for a little airflow from bottom to top.
The power supply I made it for is the Mean Well LRS-150F-12 Power Supply and the snap in EIC mains socket, so double check your dimensions before committing!
I mounted it with hot glue and then an edge of silicon. The 4 holes are not to be used with screws, as they will either touch or come incredibly close to the back of the mains. I will not be to blame if you electrocute yourself. The holes are only intended for extra surface area for glue to stick.
Unfortunately cannot be printed on the MPMD it was designed for.
Printer Brand: FlashForge
Printer: Creator Pro
Rafts: Doesn't Matter
Supports: No
Resolution: 0.21mm
Infill: 20% Gyroid
Filament: CC DIY PETG Orange
Notes:
Should work fine with any rigid material, but PETG is not very flammable and it is what I had on hand.
License:
Creative Commons — Attribution — Noncommercial
7
Noodle
