Connecting Magnetic Hearts Necklace

This fun Valentine's Day necklace consists of two hearts that connect together in the front via magnets that were embedded during the printing process (no clasp needed). 

The design is meant to fit magnets that are promoted as being 3mm by 3mm by 3mm, but they seemed to be slightly smaller than that when I measured them. 

I've provided the hearts with no square magnet spot in case you need to add your own size and shape for it. 

The magnets are not at the same height for the two sides as I tried to get the magnets as close to each other as I could so you will likely have to print them separately even if you do them the same color. 

Use PrusaSlicer's pause feature to add a pause right before the print closes over the magnet hole. 

I recommend using Support. 

Designed with Tinkercad. 

More information on Instructables: https://www.instructables.com/Connecting-Magnetic-Hearts-Necklace/