September 15, 2020
Description
This is a tetrahedron shaped lamp, which has four illuminating panels on each corner. https://www.youtube.com/watch?v=8ABmJ-hevtE
All parts print without any support and snap on to place. In addition to the printed parts, you will need a e14 cord set, seen in one of the pictures.
The lamp was printed in Glow-in-the-Dark PLA for the corners, and grey PLA for the body. The corners have a nice after glow in the dark!
Be sure to do follow your county's laws and regulations for electrical work before doing any hardware connections!
Toss a like, post a make and maybe follow me over at the IG's or YT
https://www.instagram.com/superbeasti/
https://www.youtube.com/channel/UCjYzBKKl0BfKuw2VQgK8AQg
The video shows assembly instructions, and below are the steps.
Print all parts with you favorite printer
Insert the cord through the hole on the back side
Secure the cord in the bulb holder base
Screw in the threaded body and secure the strain relief
Screw in the bulb holder base
Glue the side panels on
Insert a bulb
Put the top corner piece on
9 Finished
License:
Creative Commons — Attribution — Noncommercial
Superbeasti
