RadJet 800 Motor Mounts

Mix and match mount mount for the Radjet 800!

I created these because I have a 2836 motor in the back and an 1800mAH 4s pack in the front.

There are two problems with this idea:

(1) C of G is hopelessly out.

(2) Will the motor hold together on landing?

Use these spacers to adjust your C of G and also make the motor mount more solid.

If you have a big pack in the front then you'll need to move the motor further back to get the C of G in the right place. Use two small spacers followed by the combo spacer (and a second large spacer if needed). Bolt them all together and glue them in place.

Happy flying!

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Category: 3D Printing