Little Cities - Prusa Edition

This is the next little cities release. The Prusa Edition.
Based on the Prusa building in Prague, I've made a couple of changes to make the design more playable.

Little Cities is the start of a new 3D Printable toy series where miniature buildings and vehicles are stored within a purpose designed case until ready for play. Once play begins simply unfold the case and attach the miniature buildings to the outside of the case to create a mini play set. Each case will be themed with mini vehicles to print as well.

This one is the Prusa Edition!!!

Note - This is not a MMU print. Simply print the parts in the appropriate colours and glue them together.

To see how to carry out filament changes mid-print, please refer to the link below.
https://help.prusa3d.com/en/article/color-change_1687

Watch in awe as the transit van slides down within the Prusa building, then drive it around the back, back up the ramp back into the Prusa building and let it slide down again.

As this is part of a series I will design other themed cities, the bonus being is the cases will interlock, thus creating a bigger play-set. The roads will run in sync too.

I've designed a Little City - Burger Drive Through and a Car Wash - Petrol Garage which will be shared soon.

Please note some of the parts may cause a choking hazard, so these 3D printed toys are not recommend for children under the age of 6.

If you want to stay up to date with this series and or perhaps interested in other projects I am working on, please check out my instagram.

https://www.instagram.com/neil3dprints/?hl=en

Happy printing. :-)

Print instructions

This is not a MMU print. Simply print the parts and assemble them together.

To see how to carry out filament changes mid-print, please refer to the link below.
https://help.prusa3d.com/en/article/color-change_1687

Please refer to the images for assembly instructions.

The case I printed at 0.2mm layer height and 0.15mm for all other parts.
Refer to the file names to see if colour changes (CC) are required and for what layer heights to apply the colour changes.

The transit van wheels print in one. Be patient and gentle to loosen them so they can turn. Also use a little glue to attach the transit van together while ensuring the wheels still turn.

Any questions or queries just send me a message and I will get back to you when I can.

If you want to stay up to date with this series and or perhaps interested in other projects I am working on, please check out my instagram.

https://www.instagram.com/neil3dprints/?hl=en

Happy printing. :-)