Millennium Falcon Navigation Chair - DeAgostini Version

Navigation Chair for the DeAgostini Millennium Falcon Hold area. This is a remix of the model by aasmaticsamurai. The file has been cleaned up a little in Fusion 360, rescaled to a larger size to fit the hold area properly and everything now sits on the print bed rather than hovering in the air.

This is the chair in sections as the complete chair isn't very printable.

Print instructions

Print Settings

Printer Brand: Ultimaker

Printer: Ultimaker 2 Extended

Rafts: No

Supports: No

Resolution: 0.06

Infill: 100%

Notes:

Best to print at 30mm/sec or even slightly slower. I used an ABS/Nylon material and printed with a 4mm brim to make sure everything was held in place properly.

This is a work in progress until fully tested/fitted on the DeAgostini model. I dont have the model myself so will update here once the person I printed this for comes back to me.