Snap-fit Adapter for Prusament Spool

Snap-fit Adapter for Prusament Spool

This adapter is designed to click into a prusament spool and round the inside. 

On the inside of the prusament spool there is a notch, on which the spool can get stuck on a spool holder and not unroll freely.
For example on the voron design spool holder, the spool slides over a piece of ptfe tube and it gets stuck on the notch.
Preventing it from sliding further. 
By placing this adapter in the spool, you round off the surface so that it can rotate without resistance.

Recommended print settings:

Material: PLA, ABS or ASA. 
layer height recommended: 0.2mm.
Extrusion width recommended: 0.4mm.
Fill Type: Grid, Gyroid, Honeycomb, Triangle or Cubic.
Infill percentage recommended: 40%.
Wall count recommended: 4.
Solid top/bottom layers recommended: 5.

Printable without support!

→ Please follow, more designs soon !!! ←

→ Here you will find my other designs ←