Gü Stacker - Organiser / Stand for Gu pots

After having designed and printed TPU lids for these twee glass pots ( https://www.printables.com/model/460406-yagl-yet-another-gu-pot-lid ) we started collecting quite a few of them, and although with lids on you can stack them, if you want what is in the bottom one (or the middle) you have to try to pull that one out without collapsing the rest!

Enter the GüStacker! This allows you to easily store many Gu pots (with or without lids), holds them in small recesses to help keep them in place, and can easily be expanded to suit your collection. 

I Printed these in Matte PLA (white) and Purple (PETG). I printed 5 layers (1x base and 4x Tiers) to give a capacity of 20 pots. I wouldn't want to go much higher than 6 layers as the weight may be too much if it was lifted by the finial when fully-loaded.

Assembly of the base and tiers are by means of 30mm M5 socket-head cap screws and M5 nuts, and using keyhole slots. The Finial needs an approx' 50mm length of M5 threaded rod to be screwed into it leaving about 20-25mm protruding which then gets a M5 nut on the end of it which then can be inserted into the keyhole-slot in the top tier (not forgetting to put the Top disc on 1st) and then tightens down to secure the top and finial.

There are recesses on the bottom of each Tier & the Top disc to fit the dividing walls into. This also prevents any section from rotating and gives much more stability.