MMU2S buffer entry spacer hook, 10º angled, screwable

I really like the buffer spacer hook design by Ondřej Stříteský that adds an angle to the MMU2S buffer to decrease the curvature of the PTFE cables, but the buffer became a bit wobbly with less support, so I modified the parts to have the entire buffer supported.

Update 14/01/2022

I revisited this design because it always bothered me that these new longer space hooks for the buffer didn't have the possibility to add the nuts to secure the screws. 

Not anymore!

Added a slot on the side of the piece, has a 0.15mm tolerance so the nut will have a press-fit, after inserting it should stay easily even when moving the part around.

Printing

Printed in PETG

Support can be used but not necessary

Resolution 0.2

Infill 15%

Assembly 

Just push an M3 nut into the slot all the way before mounting the space hook into the buffer.

The space hooks have slots for screws so we can secure the buffer anywhere and in any orientation.

Since the bottom part of the space hooks is a bit big, we can also use some double-sided tape to secure the buffer in place without drilling anything.

And we can always choose to don't do any of that and just place the buffer on any surface without any additional hardware. 

Note: Be careful with the size of the screws, if you have a Prusa Enclosure V2, and the screws are too big, the two screws in the front can reach the carved part for the PTFE tube.