Hobby Vice

Here is a small hobby size vice.  I use this vice to hold wire, small printed circuit boards, etc. while soldering.  The vice has a 36mm jaw that opens to 38mm.

My design is simple.  It has three printed parts.  Should a jaw get damaged, it's a simple matter to reprint that part, alone.  I've reused a M10 bolt from another old vice.

To adjust the vice jaw gap, instead of the original 6mm steel bar, I replaced the bar with a M6 bolt that holds the knob in-place.  An M6 thread is inserted on the M10 bolt head hole.

My print is made in PLA 1.75mm Aurarum Gold filament, with 0.2mm layer height and 15% infill on a Bambu X1 Carbon printer.  Print supports required on two of the parts.  See 3MF file for parts orientation.  I used Wall Loops = 8, Infill Density of 30% Infill Pattern = Gyroid.

I hope you can find this print useful, too.

Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.