Sprial LED Lamps with Controll Hub (WLED Soundreactive)

                               Assembly instructions for the spiral lamps

To build these lamps, the following parts are required

*3 Pin connectors are also working
**1m is enough for 5 lamps (you need a total of 19 [6 + 6 + 7] LEDs per lamp)

Also required:

• soldering iron and solder
• shrink tubing
• at least a 3-wire cable (I cut up old USB cables)
• more cables/wires  to connect the microphone and GX12 connectors to the ESP32 and power
• cold appliance plug with cable
• 6x M3*12mm screw, 2x M3 washers and nuts (https://www.amazon.de/dp/B0932TNQ5H)
• 4x M3*5*5 nut heat insert (https://www.amazon.de/dp/B09B7F2XM3)

(The links are for the German amazon shop)

Wiring

Lamps

Make sure that you solder the same cables (GND, VCC and Data) to the same connections for all plugs, so that you can plug all lamps into all plugs.
In the WLED configuration, the following outputs are used for the data lines of the lamps:
25, 26, 27, 33, 12, 13, 16, 17

Microphone

Useful Links

Install WLED: https://install.wled.me (Version 0.13.3 Sound Reactive)
My WLED presets: https://howtohomemade.de/downloads/HTH_Spiral_Lamp_Presets.zip
My WLED configuration (use at own risks, uses 8A of current): https://howtohomemade.de/downloads/HTH_Spiral_Lamp_Configuration.zip

If the links don't work for you, copy the link into the address bar of your browser.
 

Demo Videos

Video of 4 spiral lamps with WLED presets changing every 30 seconds:

Video of 4 spiral lamps, with the sound reactive WLED presets: