June 28, 2023
Description
This is just a basic tool holder for the Fitnation Flex Bike Express / Ultra.
The bike came with a double open end wrench, a hex wrench and a hex wrench screwdriver combo tool. I didn't use these tools when I assembled it for my wife, so was going to toss them, but then I thought I should keep them in case it goes back to QVC, or she decides to give it away or sell it sometime down the road.
Rather than to keep track of these three oddball tools, I made a simple holder to keep them with the bike, but out of the way. This holder attaches to the top of the frame just below the handlebar, using one of the 4 screws holding the handlebar to the frame.
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
20%
Filament: Geeetech PLA Silk Silver
Notes:
It prints as oriented in the STL without supports.
Installation:
Remove one of the two screws at the top of the frame on either side holding the handlebar assembly to the frame, push the screw through the holder, then reinstall the screw with the holder attached. I put this on the right side but it really doesn't matter... It may fit equally well on the seat back, or anywhere out of the way where there's a screw to hold it.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
faultedlogic
