June 28, 2023
Description
This small enclosure is intended for use in attaching a small rocker switch "19x12mm" to power cables or small gauge extension chords.
The most common use I would think for this housing is for attaching a rocker "on/off" switch to perhaps a lamp chord. I made this to attach a much longer chord to a Christmas lit decorative glass block that a friend of my wife made for her, so it would be a good add-on for most X-mas type lighting.
It assembles easy. Insert the rocker switch, cut and strip one strand of a 2 wire supply chord, then solder the cut wires to the switch and snap the cover on.
The cover is intentionally a tight fit to prevent it from falling off of a chord that gets knocked around.
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
20
Filament: Generic PLA Depends on use...
Notes:
Prints easily as modeled with no supports.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
10
faultedlogic
