Apple AirPod Pro 2 ( USB-C ) Wireless Charging Stand

The Model should for the - IMHO - best result be printed with the front facing down as the resulting overhang with the Apple Logo has a more print friendly 50° Angle. 

Besides the obvious Apple Watch Magnetic Fast Charger you'll also be needing:
2x M3x4mm Heat Set Inserts ( I'd suggest Ruthex or CNCKitchen )
2-6x M3x6mm Flat Head Screws
4x 8x3mm Round Magnets
1x 20x40mm Strip of 3M VHB Double-sided Tape
Super Glue that works on Plastic and Metal

The Stand was designed for the particular use on my Glass Table with a magnetically attractive Steel Frame. As such to secure it I'm using both Magnets and a strip of 3M VHB Double-sided Tape… The Strip prevent it from sliding and toppling off the Frame while the Magnets will ensure a constant pressure acting on the VHB Tape.

Two of the M3x6mm Flat Head Screws ( and the Heat Set Inserts ) will be used for closing the Back Cover after the Magnetic Fast Charger was slotted into its pocket Cable in first.

Be aware that retrieving the MFC is practically impossible without destroying the Stand! To do so you'll most likely have to push through the thin section at the front to squeeze the MFC out the back.

The remaining four M3x6 can optionally be used in the slightly oversized Pockets at the bottom into which the 8x3mm Magnets go ( with some Super Glue ) to adjust their Position for a flush Surface Finish.
( obviously if you have no magnetic surface then skipping the Magnets altogether is also possible )

The 3M VHB Strip goes in-between the Magnets ( after you've inserted and routed the Charging Cable to your liking ).