ESP32_Cam mount for Prusa enXLosure

I wanted a camera inside my prusa enXLosure to connect to prusalink/ -connect.

For this upgrade you will need;

- ESP32-CAM module
- 1x M3 Heatset insert
- 1x M3x8 bolt
- Micro-USB cable (best to get right-angle)
- USB powerbrick
- You will need to print the "EnXLosure_Bottom_BR_cableguide" version or drill a hole in the corner of the part to route the power cable thru the frame

Installation;

Step 1; insert the M3 heatset insert to the first heatset hole on the inside of frontright corner.

Step 2; Place the ESP32-CAM module in the 3D printed housing. (base)

Step 3; Install the front cover of the ESP32-CAM module.

Step 4; Instal the assembled module in the front right corner of the prusa enXLosure.

Step 5; Insert te micro-USB and route it thru the side and out of the rear of the enXLosure.

Software;

For installation of the camera software, please follow the setup found here

config for software;

Please turn on both "Hmirror" and "Vflip" to get correct orientation