Three and five bit holder for the Milwaukee M12 Screwdriver (non-fuel version) that use 6mm x 3mm round magnets.
It is based off of @JPGuitars_1242953 3 bit holder. Props to him for the original design!
Instructions:
Just drop in some superglue, then press the magnets in!
BOM:
(1) m2.5 x 8mm screw
You may be able to get away with the screw that came with screwdriver that held the belt clip in by adjusting the parameter “ScrewTabThickness”
(5) 6mm diameter x 3mm thick magnets (you can adjust the parameter “MagnetHoleThickness” in the fusion file if yours aren't exactly this. I have had “3mm” thick magnets that were 2.8mm before).
Long
