Assembly
use brim for better adhesion.
- print 4 outer legs ( front and rear ) with stripe on the side and twin toe
- print 4 inner legs (middle) without stripe
- print body
put legs together in warm water to reduce cracking. Or use print in place legs.
Ball joint is printed upside down!
- ball (turn upside)↦ leg ••• ⇒ leg •• ⇒ leg • ⇒ toe
- press ball into body (8×) while wiggle and twisting, add a little grease for easier assembly
- heat a 1.5cm filament in the center and fold - then press into the head as teeth.
- add a drop paint on the 6 eyes to make them black glossy
- thread a thread through the gaster
Have fun with your spider
Jack
