February 14, 2024
Description
Easy to print paperweight that also decorates your office
It uses less than 50grams of filament total, so you can take advantage of almost any unfinished roll to print.
Printing Tips:
-check your sliced file before printing to make sure text lines will print well. The result may vary depending on your nozzle, so you can change the “thin walls” parameter until you get it right.
-the tolerances are a little tight, so make sure you don't have "elephant foot” in your printer to get them to fit right. if you can't avoid it then you just have to scrape or sand the base of each piece a little to make it fit. And if they are a little loose, use some glue to hold them
Print Settings
Material: PLA / PETG
Layer height: 0,16 - 0,24
Nozzle diameter: 0,4mm or 0,6mm
Infill: 10 -12%
Perimeters: 2
Supports: no
yo can check all my designs here
________________________
If you like my designs and want to support me or sell physical prints, you can check out my patreon
https://www.patreon.com/meafdesigns
________________________
License:
Creative Commons — Attribution — Noncommercial — Share Alike
MEAFdesigns
